Filter
Top Products
Brocade ICX 6650 Administration Guide 249
53-1002600-01
Basic system management
11
Viewing egress queue counters
The show interface command displays the number of packets on a port that were queued for each
QoS priority (traffic class) and dropped because of congestion.
NOTE
These counters do not include traffic on management ports or for a stack member unit that is down.
The egress queue counters display at the end of the show interface command output as shown in
the following example.
Syntax: show interface [ethernet <stack-unit>/<slot>/<port>]
Specify the Ethernet port in the <stack-unit>/<slot>/<port> format. Stack-unit is 1.
Table 54 defines the egress queue statistics displayed in the output.
Brocade#show interface e 1/1/1
GigabitEthernet1/1/1 is up, line protocol is up
Hardware is GigabitEthernet, address is 748e.f80c.5f40(bia 748e.f80c.5f40)
Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx
Configured mdi mode AUTO, actual none
Member of L2 VLAN ID 52, port is untagged, port state is FORWARDING
BPDU guard is Disabled, ROOT protect is Disabled
Link Error Dampening is Disabled
STP configured to ON, priority is level0, mac-learning is enabled
Flow Control is config enabled, oper enabled, negotiation disabled
mirror disabled, monitor disabled
Not member of any active trunks
Not member of any configured trunks
No port name
Inter-Packet Gap (IPG) is 96 bit times
IP MTU 1500 bytes
300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
300 second output rate: 256 bits/sec, 0 packets/sec, 0.00% utilization
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 multicasts, 0 unicasts
0 input errors, 0 CRC, 0 frame, 0 ignored
0 runts, 0 giants
215704 packets output, 13805066 bytes, 0 underruns
Transmitted 0 broadcasts, 215704 multicasts, 0 unicasts
0 output errors, 0 collisions
Relay Agent Information option: Disabled
Egress queues:
Queue counters Queued packets Dropped Packets
0 0 0
1 0 0
2 1 0
3 0 0
4 0 0
5 0 0
6 0 0
7 215703 0