Filter
Top Products
Brocade ICX 6650 Administration Guide 47
53-1002600-01
Basic port parameter configuration
2
Displaying loop detection configuration status on an interface
Use the show interface command to display the status of loop detection configuration on a
particular interface.
Brocade# show interface ethernet 1/1/1
10GigabitEthernet1/1/1 is disabled, line protocol is down
Hardware is 10GigabitEthernet, address is 748e.f80c.5f40(bia 748e.f80c.5f40a)
Interface type is 1Gig Copper SFP (miniGBIC)
Configured speed 1Gbit, actual unknown, configured duplex fdx, actual unknown
Member of 1 L2 VLANs, port is tagged, port state is DISABLED
BPDU guard is Disabled, ROOT protect is Disabled
Link Error Dampening is Enabled
STP configured to ON, priority is level0, mac-learning is enabled
Loop Detection is ENABLED
Flow Control is disabled
Mirror disabled, Monitor disabled
Not member of any active trunks
Not member of any configured trunks
No port name
MTU 10200 bytes, encapsulation ethernet
300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 multicasts, 0 unicasts
0 input errors, 0 CRC, 0 frame, 0 ignored
0 runts, 0 giants
0 packets output, 0 bytes, 0 underruns
Transmitted 0 broadcasts, 0 multicasts, 0 unicasts
0 output errors, 0 collisions
Relay Agent Information option: Disabled
Egress queues:
Queue counters Queued packets Dropped Packets
0 0 0
1 0 0
2 0 0
3 0 0
4 0 0
5 0 0
6 0 0
7 0 0
Syslog message due to disabled port in loop detection
The following message is logged when a port is disabled due to loop detection. This message also
appears on the console.
Loop-detection: port 1/1/35 (vlan=1), put into errdisable state
The Errdisable function logs a message whenever it re-enables a port.
size The size
init The number of requests initiated
TABLE 11 Field definitions for the show loop-detection resource command (Continued)
Field Description