Filter
Top Products
CHAPTER 3 CONTROL PANEL
3–5
Lamp Lit Choice Function
Drum
Test sample page The printer prints a test sample page.
The printer returns to the ready status after
printing.
Alarm
Print Config & Print
Fonts I
The printer prints the current configuration of
the printer and a list of the internal fonts.
The printer returns to the ready status after
printing.
Ready
Factory Reset The printer is restored to the factory setting and
permanent fonts and macros are cleared.
The printer returns to the ready status after
printing.
Data
Hex Dump Print The printer can print data as hexadecimal values,
so that you can check data errors and problems.
To exit from this mode, you have to turn off the
printer.
Control Features Set by the Brother Driver
Page Protection
If the printed images are too complex to print, the printer may print a
partial image on the page. If this occurs, the printer has lost some print
data and will indicate a “print overrun” error by printing an error report.
The page protection feature allows the printer to create the image to be
printed in memory before physically moving the paper through the
printer. Therefore, setting page protection to ON may eliminate the
“PRINT OVERRUN” error.
The “AUTO” setting does not require additional memory and
automatically uses page protection only when it is necessary.
Occasionally, when AUTO page protection is on, processing complex
print data may be slightly delayed.