Filter
Top Products
CHAPTER 4 OPTIONS
4–7
The following type of SIMMs can be installed:
• 1 MByte HITACHI HB56D25632B-6A, -7A
• 2 MByte HITACHI HB56D51232B-6A, -7A
• 4 MByte HITACHI HB56A132BV-7A, 7AL, -7B, -7BL
• 8 MByte HITACHI HB56A232BT-7A, -7AL, -7B, -7BL
• 16 MByte TOSHIBA THM324000BSG-70
• 32 MByte TOSHIBA THM328020BSG-70
This printer can accept the following types of SIMMs;
Speed 60 nsec - 80 nsec
Pin Type 72 pin
Height
25.4
mm (
1
") or less
Output 32 bit or 36 bit
✒ Note
The printer has only one slot for a SIMM upgrade.If you want to increase
your printer memory again after you have installed a SIMM module into
the slot, you will need to remove the previously installed SIMM first. For
example if you have previously increased your memory from the standard
4 MB to 8 MB by adding a 4 MB SIMM and you wish to increase your
total memory to 12 MB, you need to remove the installed 4 MB SIMM
and install the new 8 MB SIMM into the printer.
Installing the SIMM
When you install the SIMM, follow these steps:
1.
Turn off the power switch and unplug the power cord from the AC
outlet. Then, disconnect the interface cable from the printer.
Fig. 4-3 Unplug the power cord and
disconnect the interface cable
✒ Note
Be sure to unplug the power cord to the printer before installing or
removing the SIMM and the main controller board.