Filter
Top Products
USER’S GUIDE
3–6
English
Test Print Mode
The printer has a test print mode where you can select and perform any of
three test prints. Follow these steps:
1. Press the SELECT switch to turn the printer off-line.
2. Hold down the FF/CONT switch and press the SELECT switch.
The printer enters the test print mode. The ALARM lamp blinks to
indicate that the first choice, Test sample page, is selected. See the
table below.
3. Press the FF/CONT switch to select another test.
Every time you press the switch, the blinking lamp changes to select
another choice. See the table below.
4. Press the SELECT switch to perform the selected choice.
Blinking Lamp Choice Function
ALARM Test sample page The printer prints a test
sample page.
READY Print Fonts I & P The printer prints a list of the
internal or resident fonts of
the printer. If permanent fonts
are downloaded into the
printer memory, the printer
also prints a list of permanent
download fonts.
DATA Print Config The printer prints the current
settings that configure or set
up the printer.
MANUAL Enable/disable the test
print
The test print set by TEST
switch is enabled or disabled.
After printing the desired test sample page, the printer returns to the ready
status.