Brother 3200c All in One Printer User Manual


 
ASSEMBLY AND CONNECTIONS
2 - 14
MFC3200C-US-FM6.0
Connections
The external TAD
must
be plugged into the back side of the MFC, in the jack
labeled EXT. Your MFC cannot work properly if you plug the TAD into a wall
jack (unless you are using Distinctive Ring).
1
Plug the telephone line cord from the wall jack into the back side of the MFC,
in the jack labeled LINE.
2
Plug the telephone line cord from your external TAD into the back side of the
MFC, in the jack labeled EXT. (Make sure this cord is connected to the TAD at
the TADs telephone line jack, and not its telephone set jack.)
3
Set your external TAD to four rings or less. (The MFCs Ring Delay setting does
not apply.)
4
Record the outgoing message on your external TAD (see page 2-15).
5
Set the TAD to answer calls.
6
Set the Receive Mode to
TAD:ANSWER MACH.
.
(See
Choosing the Receive Mode
, page 6-1.)
If You Do Not Subscribe to Distinctive Ring Service:
You
must
plug your TAD into the EXT. jack of your MFC. If your TAD is
plugged into a wall jack, both your machine and the TAD will try to control the
phone line. (See illustration on page 2-14.)
Do not connect a TAD elsewhere on the same phone line
(unless you have
the Distinctive Ring service).
TAD
TAD