Filter
Top Products
USER’S GUIDE
3-4
Test Print Mode
The machine has the following test print mode. Follow these steps:
1. Make sure that the top cover is closed.
2. Hold down the switch and turn on the
power
switch. Keep the
switch
depressed until the
Drum
lamp comes on.
The
Drum
lamp lights to indicate that the machine is in the test print
mode.
3. Press the
switch
again to execute the test print or hold down the
switch
to select another option and release the
switch
to execute the
selected option.
The test print modes are listed below:
Lamp Lit Choice Function
Drum
Test sample page The machine prints a test sample page.
The machine returns to the ready status after
printing.
Alarm
Print Config & Print
Fonts I
The machine prints the current configuration of
the machine and a list of the internal fonts.
The machine returns to the ready status after
printing.
Ready
Factory Reset The machine is restored to the factory setting
and permanent fonts and macros are cleared.
The machine returns to the ready status after
printing.
Data
Hex Dump Print The machine can print data as hexadecimal
values, so that you can check data errors and
problems. To exit from this mode, you have to
turn off the machine.