Filter
Top Products
20
Entering bar code data
1 Press c.
2 Type in the new bar code data or edit the old data.
3 Press n to add the bar code to the text.
The following special characters can only be added to bar codes created using protocol
CODE39 or CODABAR.
☞ To add special characters to the bar code data (only with protocols CODE39,
CODABAR, EAN128 or CODE128), position the cursor below the character
immediately to the right of where you wish to add the special character, and then
press
s. Press u or d until the desired special character is displayed, and
then press
n to add the character to the data. (Refer to the tables below for a list
of the special characters that are available.)
☞ To change the data or WIDTH or UNDER# parameter settings of a bar code that has
already been added to the text, position the cursor below the bar code mark ( ), and
then press
g, then c.
☞ If the tape is to small the P-touch will automatically adjust the bar codes to prevent
the misreading or unreading by bar code reader.
CODE39 CODABAR
Symbol
Character
Symbol
Character
Symbol
Character
Symbol
Character
0
– 4/ 0– 3/
1.5+ 1$4.
2 (SPACE) 6 % 2 : 5 +
3$