Filter
Top Products
28
CHAPTER FOUR
Setting Volume Amplify
Please carefully read “Setting the Handset Volume” before you do the
following steps:
1
Press
Function
,
1
,
5
.
SELECT <- -> & SET
VOL AMPLIFY:OFF?
2
Press or to select VOL AMPLIFY:OFF? if none of the
users are hearing-impaired and go to Step 4—OR—If some or all of the
users are hearing-impaired, select VOL AMPLIFY:ON?.
SELECT <- -> & SET
PERMANENT?
3
Press or to select PERMANENT? if all the users are
hearing-impaired—OR—Select TEMPORARY? if only some of the
users are hearing-impaired.
4
Press
Set
.
5
Press
Stop
to exit.
Setting the Speaker Volume
You can adjust the speaker volume when your fax machine is onhook (after
you pressed
Speaker Phone
), by selecting a speaker volume level.
Press or to adjust the volume level. The display shows the setting
you are choosing. Each key press changes the volume to the next setting.
The new setting will remain until you change it again.
You can adjust the speaker volume while you are listening to your OGM
(Outgoing Message) and ICMs (incoming messages).
If you turn the Incoming Recording Monitor to OFF (
Function
,
8
,
5
), the
Speaker for screening calls will be disabled and you will not be able to hear
callers leaving messages. The volume for other operations can still be
controlled using and .