Filter
Top Products
Wireless configuration using the PIN Method of Wi-Fi Protected Setup™ (For HL-2170W)
82
7
d Wait for the Ready LED (Go button) of your printer to indicate connection succeeded. (See the table
below) This indication means the machine has successfully connected to your access point / router. You
can now use your printer on the wireless network.
If the LED indicates connection failed (See the table below), the machine has not successfully connected
to your router or access point. Try starting from a again. If the same message is indicated again, reset
the machine back to the default factory settings and try again. For resetting, see Restoring the network
settings to factory default on page 100.
1
The LED will blink (turn on for 0.2 seconds and off for 0.1 second).
2
The LED will turn on for 5 minutes.
3
The LED will blink (turn on for 0.1 second and off for 0.1 second) for 30 seconds.
You have completed the wireless setup. To install the printer driver, Go to step a on page 83
for Windows
®
or page 87 for Macintosh
®
.
LED indications when using the one-push wireless setting mode
LEDs Searching or accessing
the access point
1
Connecting and
downloading the settings
from the access point
1
Connection
succeeded
2
Connection failed
3
Toner
(Yellow)
Drum
(Yellow)
Error
(Red)
Ready
(Blue)