Filter
Top Products
For Network Users
53
How to set the machine’s
network settings to wireless
LAN or wired LAN
To connect your Brother machine to a wireless or
wired network you must configure the machine from
the machine’s control panel for the network type you
are using.
For wireless LAN
On your machine, press Menu, 6, 2, 5 then press
or to choose On, and then press OK.
For wired LAN
On your machine, press Menu, 6, 1, 4 then press
or to choose On, and then press OK.
Note
In case that you choose On for both wireless LAN
and wired LAN, if the network cable is connected
to the machine, the wired network interface will be
active. If the cable is not connected to the
machine, the wireless network interface will be
active.
Restoring the network
settings to factory default
To restore all network settings of the internal
Print/Scan server to factory default, please follow the
steps below.
1 Make sure the machine is not operating, then
disconnect all the cables from the machine
(except power cable).
2 Press Menu, 6, 0.
3 Press 1 to select Reset.
4 Press 1 to select Yes.
5 The machine will restart, re-connect cables
once this is complete.