Brother PT-1500PC Printer User Manual


 
3
Inserting a photo into the photo frame
1 Remove the photo frame from the
PT-1500PC by carefully pulling off the
frame, grabbing it from the back of the
PT-1500PC as shown.
Be careful that the tape compartment
cover is not opened when removing
the photo frame.
2 Remove the cardboard backing and the
clear protective sheet from the photo
frame.
3 Stack the clear protective sheet, the
photo, and the cardboard backing in that
order, facing down.
4 Insert one end of the stack under the two
tabs on one side of the frame, and then
insert the stack under the two tabs on the
other side of the frame.
5 Attach the photo frame to the side of the
PT-1500PC opposite to the tape
compartment cover.
•Without removing the cardbord backing and
the clear protective sheet from the photo frame
Slide the photo between the cardbord
backing and the clear protective sheet.
D
C
I
N
9
.
5
V
Tape cassettes
Do not pull on the tape being fed from the machine, otherwise the tape cassette may be damaged.
If the label is attached to a wet or dirty surface, it may easily peel off. Before affixing the label, clean
the surface where it will be attached.
Depending on the environmental conditions and the material, condition, roughness, and shape of
the affixing surface, the label may move out of place or peel off. In order to test the label’s adhesive
strength or before using this label where safety is a particular concern, test the label by affixing a
small piece of it to a hidden area of the intended surface.
Sunlight, wind and rain may cause the color of the label to fade or the label to peel off.
•Markings made with oil-based or water-based ink may be visible through a label affixed over them.
To hide the markings, use two labels layered on top of each other, or use tape with a dark back-
ground.
This tape may not be adequate in cases where liabilities may result due to damage or injuries.
A photo can be inserted into the photo frame attached to the PT-1500PC, turning it into a decorative
addition to your workspace.
Insert a photo into the photo frame in either of the following two ways:
By removing the photo frame from the PT-1500PC