Filter
Top Products
Getting started
10
1
Press the ON/OFF button to turn the QL-560
off. Hold the DK Roll compartment cover at the
sides near the front of the QL-560 and firmly lift
up to open the cover.
2
Place the spool into the spool guides in the DK
Roll compartment.
• Make sure that the spool arms are inserted firmly in
the spool guides on the left and right.
• Insert the spool with the DK Roll located on the right
hand side of the QL-560.
3
Lift the label lever and then thread the
end of the DK Roll into the slot
immediately before the cutter.
When unable to thread the end of the DK
Roll into the slot, thread it as far as
possible, then lower the label lever and
close the cover. Press the ON/OFF button
to turn the QL-560 on, and then press the
FEED button to set the roll.
4
Lower the label lever and then close the DK
Roll compartment cover.
3 Installing the DK Roll