Filter
Top Products
26
PCATX-R9 User’s Guide
Installing Internal Drives
Your FieldGo workstation has space for five half-height drives. Two 5.25” and
two 3.5” drives are externally accessible. One internal drive space accommo-
dates a 3.5” drive.
To begin installing or removing a drive, follow these steps to detach the drive
housing from the chassis:
1. Shut down the system and unplug the power cord from the power
supply.
2. Set your workstation in its upright position with the back cover facing
you.
3. Refer to Figure 3.1 to first remove the back cover.
4. Internal space is tight. You’ll need to pull out the drive housing to add or
remove a drive. Carefully unplug data and power cables attached to
drives already installed in the system. Make a note of how they were
originally connected. Especially note the orientation of the flat ribbon
cables.
5. The drive housing is attached to the system chassis by screws indicated
by the arrows in Figure 3.5. Remove those screws.
6. Carefully pull out the entire drive cage assembly towards you.
Adding Components