Filter
Top Products
27
PCATX-R9 User’s Guide
Note that the 5.25” drives are vertically mounted inside the drive housing. If
you need to add or remove any 5.25” drive, all of the 3.5” drives initially
installed inside the drive housing must be first removed to give you access
to the mounting screws on the bottom side of the 5.25” drives.
Figure 3.5
Procedures for removing the drive
housing from the system chassis to add
or remove drives: (1) First remove
screws at A and B. (2) Remove all data
and power cables and then carefully pull
the drive housing out.
Top mounting screws for 5.25”
drives. Bottom mounting screws are
blocked by the 3.5” drives.
A
B
3.5” drive mounting screws.
Remove screws at A and B.
Adding Components