Cable Electronics HSW44C Switch User Manual


 
12
Source Side
Method A: Push Button
Push the switch button on the front panel, the source will be sequentially changed.
Method B: IR Remote Control
a. Please press to enter IR control mode
Note
If HSW44C receives the IR commands, the LED will flash. If not, try again.
b. Decide which output port to be controlled by pressing F1 to F4
Note
If the setting is correct, the corresponding LED will flash. If not, please press output port select button or repeat
step (a) and (b).
F1 HDMI output #1
F2 HDMI output #2
F3 HDMI output #3
F4 HDMI output #4
c. Use or keys to select input source.
Note
If the setting is correct, the corresponding LED will flash. If there is no
response, please wait until the LED stops flashing, and try again.
Left button to switch channels in ascending order (1, 2, 3, 4, 1, ...)
Right button to switch channels in descending order (1, 4, 3, 2, 1, …)
Operation and IR Control