Filter
Top Products
Installation 3-1
3
Installation
This chapter provides the instructions required to install the 2H253-25R. A Phillips screwdriver is
required to install options into the device or install the device into a rack. Follow the order of the
sections listed below to correctly install the device.
• Unpacking the Device (Section 3.1)
• Installing Options (Section 3.2)
• Installing the Device (on a shelf or tabletop, or into a standard rack) (Section 3.3)
• Connecting to the Network (Section 3.4)
• Completing the Installation (Section 3.5)
3.1 UNPACKING THE DEVICE
Unpack the device as follows:
1. Open the box and remove the packing material protecting the 2H253-25R.
2. Verify the contents of the carton as listed in Table 3-1.
Only qualified personnel should install the 2H253-25R.
NOTE
Read the Release Notes shipped with the device to check for any exceptions to the
supported features and operation documented in this guide.