Filter
Top Products
Chapter 3: Installation
3-14 ESX-1320/ESX-1380 Installation Guide
3.7.2 Rackmount Installation
To install the ESX in a 19-inch rack, Cabletron Systems includes an
accessory kit containing the rackmount brackets, mounting screws for
attaching the rackmount brackets to the ESX chassis, and a strain-relief
bracket for cable management. Screws to mount the ESX to the rack rails
are provided by the user.
Guidelines for the Rackmount Installation
The installation site must be within reach of the network cabling and meet
the requirements listed below:
• An appropriate grounded power receptacle must be located within
seven feet of the location.
• Maintain a temperature of between 5°C (41°F) and 40°C (104°F) at
the installation site with fluctuations of less than 10°C per hour.
• In order to allow for proper cooling, there must be a two-inch
clearance on either side and the back of the unit.
Installation
Rack mounting the ESX involves the following:
• Attaching the strain-relief bracket
• Rack mounting the ESX (attaching the mounting brackets and
fastening the ESX to the rack)
Attaching the Strain-Relief Bracket
Attach the strain-relief bracket to the front of the ESX as follows:
1. Locate the strain-relief bracket and four 8-32 x 3/8-inch pan head
screws in the rackmount kit.
2. Attach the strain-relief bracket to the bottom of the ESX using the four
8-32 x 3/8-inch pan head screws (Figure 3-10).
Do not use longer screws to attach the strain-relief bracket.
Longer screws could contact electrical components and cause
personal injury and/or damage the unit.