Filter
Top Products
Using the LCD
ESX-1320/ESX-1380 Installation Guide 4-9
4.4.2 Static System Messages
The Static System Messages provide ESX configuration information. The
product name must be displayed on the LCD before you can start stepping
through the messages in the sequence shown in Table 4-3.
To Display the Messages
With the product name (e.g., CABLETRON ESX-1320) displayed,
momentarily press the DISPLAY button to step to the first message. Each
time you press the DISPLAY button, the next message is displayed until
the last message. Then the display automatically exits to the product
name.
To Exit
There are three ways to exit the Static System Messages:
• From the last Static System message
Momentarily press the DISPLAY button while the last message
“COM 2 Port Function xxxxx” is displayed. The display automatically
returns to the product name.
• Automatic 20-second exit
Allow 20 seconds to elapse after the last DISPLAY button operation.
The display returns to the product name.
• Jump to Alarm Messages
Press and hold the DISPLAY button for 3 seconds. When released, the
display steps to the Alarm Messages described in Section 4.4.3.
NOTE
Whether you are displaying Static System Messages, Alarm
System Messages, or Saved System Messages, the display
returns to the product name display 20 seconds after the last
operation of the DISPLAY button.