Filter
Top Products
SEH USER’S GUIDE 3-1
CHAPTER 3
INSTALLATION
This chapter outlines the procedure for attaching the SEH to a network as
either a stackable or standalone device. Ensure that the network meets the
guidelines and requirements outlined in Chapter 2, Installation
Requirements/Specifications, before installing the SEH.
3.1 UNPACKING THE SEH
Unpack the SEH as follows:
1. Remove the shipping material covering the SEH in the shipping box.
2. Carefully remove the SEH from the shipping box.
3. Remove the SEH from the protective plastic bag and set it aside to
prevent damage.
4. Visually inspect the SEH. If there are any signs of damage, contact
Cabletron Systems Technical Support immediately.
3.2 INSTALLING THE SEH
The SEH may be installed on a tabletop or shelf, or in a 19-inch rack, and
configured as a standalone or stacked hub.
Refer to Section 3.2.1 for information concerning a tabletop or shelf
installation. Section 3.2.2 describes the rackmount installation.
Failure to follow installation instructions may result in an
electrical shock hazard.
SEH Book Page 1 Tuesday, March 19, 1996 4:12 PM