Filter
Top Products
INSTALLATION
Page 3-6
3.4 SETTING THE RING SPEED SWITCH
This section explains how to change the TRXI’s ring speed from the
factory default setting of 16 Mbps to 4 Mbps. To change the ring speed,
you need to set the switch located inside the TRXI as shown in
Figure 3-6. You can access the switch through the air vent with a
small screwdriver.
To change the ring speed:
1. Turn off the TRXI.
2. Place a small screwdriver through the TRXI’s air vent to access the
Ring Speed Switch.
3. Use the screwdriver to slide the switch to the desired setting as
shown in Figure 3-6.
4. Turn on the TRXI.
5. Check that the Ring Speed LED indicates the correct setting.
Figure 3-6. The Ring Speed Switch
DISPLAY
TRXI-24A TOKEN RING HUB WITH LANVIEW®
RING SPEED SWITCH SETTINGS
4 Mbps
16 Mbps
Ring Speed LED Indicator
On = 16 Mbps
Off = 4 Mbps