Filter
Top Products
35
14. Basic Scanning Procedure
This section describes the basic procedure for scanning documents using the device.
Based on the type of connector installed on the ShareScan Administration Console PC, you can send scanned data to other
computers and devices on a network. This section describes the procedure for sending scanned data to another computer.
❏ Preparing for Scanning
Before scanning, you must configure a Connector on the
ShareScan Administration Console PC, and configure the
scanning conditions and destination for scanned data. For
details, refer to the eCopy ShareScan 5.0 Installation
Guide (electronic manual) or the Help.
❏ Scanning Procedure
1. Confirm the scan settings in the Home screen and
change them as necessary.
The scan settings appear at the left in the Home screen.
The scan settings displayed here are the same as those
configured on the ShareScan Administration Console PC.
By pressing a setting item, you can display the
configuration for that item and change it as necessary.
2. Place a document in the device.
3. Press a task button in the Home screen.
Document scanning starts. The Preview screen appears,
and the scanned pages are displayed in order. Proceed to
the next step when all the pages in the feeder are scanned,
and the last page of the document appears on the Preview
screen.
4. Manipulate the scanned data on the Preview screen
as necessary.
You can manipulate the scanned data by pressing the
buttons on the Preview screen. For details on each button,
see “Preview Screen” on p. 37.