Filter
Top Products
5
5. Using On-Screen Menu
Enabling Password [Password]
This feature turns on or off the Password function.
Unless the correct password is entered, the projector cannot project an image. (
→
page 37)
Selecting Menu Color [Menu color select]
You can choose between two color modes for menu color: color and monochrome.
Selecting Menu Display Time [Menu display time]
This option allows you to select how long the projector waits after the last touch of a button to turn off the menu.
The preset choices are [Manual], [5 sec], [15 sec], and [45 sec].
Selecting a Color for Background [No signal screen]
Use this feature to display a blue, black screen or the Canon logo screen when no signal is available.
Selecting Interval Time for Filter Message [Filter message] (LV-7365 only)
The projector has a feature that informs you of the timing for cleaning the lters.
This item allows you to select the time preference between displaying the message for cleaning the lters. Clean
the lter when you get the message "Please clean lter." (
→
page 56)
Five options are available: Off, 100(H), 200(H), 500(H), 1000(H)
The default setting is 500(H). Change the interval time depending on the degree of dust and dirt on the lters.
NOTE:
1) The message for lamp replacement and filter cleaning will be displayed under the following conditions:
- one minute after the projector has been powered on.
- when the POWER ON/STAND BY button on the projector cabinet or the POWER OFF button on the remote control is pressed.
To cancel the message, press any button on the projector cabinet or the remote control.
2) Your setting will not be affected even when [Reset] is done from the menu.
[Options]
Setting Off Timer [Off timer]
You can use the Off Timer feature to turn off the projector automatically at a preset time.
Eight preset times can be selected:Off, 0:30, 1:00, 2:00, 4:00, 8:00, 12:00 and 16:00.
Setting Auto Adjust [Auto PC adjustment]
Selecting [Normal] or [Fine] will automatically execute Auto PC adjustment function at the time of signal switching.
This feature sets the Auto PC adjust mode so that the analog RGB image can be automatically or manually adjust-
ed for noise and stability. You can automatically make adjustment in two ways: Normal and Fine
Off .......................... The RGB image will not be automatically adjusted.
You can manually optimize the RGB image.
Normal ...................Default setting. The RGB image will be automatically adjusted. Normally select this option.
Fine ........................Select this option if fine adjustment is needed. It takes more time to switch to the source than when [Nor-
mal] is selected.
LV-7265/LV-7260/LV-X7
LV-7365