Filter
Top Products
When DIP switch 12 is OFF, the printer control mode is set by DIP
switch 11 (OFF selects BJ-10 mode, ON selects Epson LQ mode).
Automatic emulation mode is applicable for MS-DOS applications only.
When you are using Windows, the BJ-200e printer driver for Windows
selects the appropriate control mode regardless of the settings of DIP
switches 11 and 12.
Setting DIP switch 12 ON reduces the input buffer by 9.4 KB.
When using Windows, set DIP switches 10, 11 and 12 OFF to maximize
the size of your input buffer (50.4 KB).
Epson LQ Mode
When the printer is in Epson LQ mode (DIP switch 11 is ON), you can
set the DIP switches to control the following functions:
NOTE:
If the printer does not seem to be switching between BJ-10 and
Epson LQ mode, disable this function and set DIP switch 11 to
match your application's printer driver.
If you are using a printer switching device, you must allow at
least ten seconds for the printer to recognize an emulation
change. If your printer switching device switched data in less
than ten seconds, automatic emulation switching will not
function properly.
DIP
switch
Function OFF ON
1 Horizontal print
position
Letter size or
COM 10 envelope
A4 size or
DL size
envelope
2 Text scale mode Disabled Enabled
3 Page length 11 inches 12 inches
4 Character set Italics Graphics
5, 6, 7 International
Character
Set
See following
descriptions
8, 9, 10 Typeface See below