Filter
Top Products
on OK to exit the TrueType dialog box.
12. Click on Close to exit the Fonts dialog box.
Your installation is now complete.
If you would like to remove the installed fonts, please refer to the
instructions that came with your TrueType Fonts.
Setting Up WordPerfect for Your Printer
This section contains the procedures you perform to install the Bubble
Jet Printer BJ-200e driver for WordPerfect, version 5.1 or 6.0, for MS-
DOS. These instructions assume you have installed WordPerfect and are
familiar with using it.
1. Make sure your computer is turned on.
2. Make a backup copy of the diskette containing the Canon BJ-
200e printer drivers for WordPerfect (if you have not already
done so).
3. At the MS-DOS prompt, copy the WordPerfect driver, either
WP51BJ2E.ALL or WP60BJ2E.ALL, to your WordPerfect
directory. For example, if you are using WordPerfect 5.1 and your
directory is WP51, you insert the diskette with the drivers into
drive A and type this command:
COPY A:WP51BJ2E.ALL C:\WP51
If you are using WordPerfect 6.0 and your directory is
wp60, insert the driver diskette into Drive A and type:
COPY A:QP60BJ2E.ALL C:\WP60
4. Change to the WordPerfect directory and start WordPerfect by
typing WP and pressing Enter.
5. At the document screen, press Shift + F7.
6. At the Print Options menu, type S to select printer.
7. At the Select Printer menu, type 2.
8. At the additional Printers menu, highlight the BJ-200e driver and
press Enter.
9. When the printer file name appears at the bottom of the screen,
NOTE: If you select the BJ-200e LQ driver, make sure you set DIP
switch 11 to ON for Epson LQ mode. See Chapter 8, Customizing the
Printer, for details.