Filter
Top Products
Flow of Copy Operations
1-8
Introduction to Copying
1
● If you want to cancel a copy job in the standby mode:
❑ Press [Stop].
The display for selecting a copy job to cancel appears.
❑ Press [F2] (▼) or [F3] (▲) to select the copy job you want to cancel ➞ press
[F4] (CANCEL).
The selected job is canceled.
NOTE
After pressing (Stop), several copies may continue to print out.
You can also cancel a copy job from the System Monitor screen. (See "Using the
System Monitor Screen," on p. 1-17.)
● If you want to interrupt a copy job:
❑
To interrupt a copy job when you need to make priority copies, press [Interrupt].
For instructions on interrupting a copy job, see "Interrupt Mode," on p. 1-20.
The message <ABLE TO PERFORM INTERRUPT JOB> appears on the LCD
display.
● If you want to reserve a copy job and scan an original while the
machine is printing:
❑ Place your original ➞ press [Start].
For instructions on reserving a copy job, see "Reserved Copying," on p. 1-18.
8
When scanning is complete, remove your original.
9
If you have set Department ID Management, press [ID].
For instructions on using Department ID Management, see Chapter 5, "System
Manager Settings," in the Reference Guide.
Stop
F2
F3
F4
Interrupt
Start
ID