Filter
Top Products
9
Quick Start Instructions
Those who wish to start scanning immediately should follow the procedures below. If
you require further information at any stage, read the pages referenced at each step.
Installing Plug-in Module CS-U p. 13
1. Place the Macintosh version of the CanoScan Setup CD-ROM
that came with the scanner into the computer’s CD-ROM drive.
The CanoScan Setup Utility will automatically start. (If the
CanoScan Setup Utility does not automatically start, double-
click the [CanoScan FB630U/636U] icon, followed by the
[Setup] icon.)
2. Click [Install the Software] and install Plug-in Module CS-U.
(Install Adobe PhotoDeluxe 2.0 first.)
If Adobe PhotoDeluxe 2.0 has not yet been installed, install it
before Plug-in Module CS-U.
Start Plug-in Module CS-U p. 19
1. Connect the scanner to the computer, then start Adobe
PhotoDeluxe 2.0.
2. Select [CanonPI CS-U 3.3.0...] as the image source (this step is
only required the first time the scanner is used with the
program)
3. Click the scanner icon.
• Plug-in Module CS-U will start and display its control panel.
Start the Preview Scan p. 21
1. Place the materials to be scanned on the scanner.
2. Click the preview scan button ( ).
• The entire document glass area will be scanned and displayed in the
preview scan window.
Preview Window
Plug-in Module CS-U automatically calibrates itself the first time the preview or
scan button is clicked. The scanner will run by itself for a few moments without
displaying an image in the window. This does not constitute a breakdown. The
calibration results are stored until the computer power is shut off.
1
1
2
2
3
3
➟