Filter
Top Products
54
This function enables you to capture an image
being projected to use it for a starting-up display
or interval of presentations.
Select and press the OK button.
A confirmation box appears and select to
capture the projected image.
After capturing the projected image, go to the
Logo select function and set it to User. Then the
captured image will be displayed the next time
you turn on the projector or when you press the
BLANK button (p 29).
To cancel the capture function, select in the
"Quit?" confirmation box.
• Before capturing an image, select in the
Image select Menu to capture a proper image (pp.
35,44).
• A signal from a computer can be captured up
to panel size (1024 x 768). (Only for LV-7292A,
LV-7297A, LV-7392A, LV-7292M, LV-7297M)
• A signal from a computer can be captured up to
panel size WXGA (1280 x 800). A signal from video
equipment can be captured except for 1035i and
. (Only for LV-8227A, LV-8227M)
• When capturing the image that has been adjusted
by the Keystone function, the adjusted data is
automatically reset and the projector captures an
image without keystone correction.
• When Logo PIN code lock function is set to On,
and can not be selected.
• When starting to capture a new image, the
previously stored image is cleared even if you
cancel the capturing.
• When there is no captured image or it is interrupted
while capturing an image, User can not be selected,
you can only switch between and .
This function prevents an unauthorized person
from changing the screen logo.
.......... The screen logo can be changed
freely from the Logo Menu (p. 53).
On .......... The screen logo cannot be changed
without a Logo PIN code.
If you want to change the
setting, press the OK button and the Logo PIN
code dialog box appears. Enter a Logo PIN code
by following the steps below. The initial
is set to “4321” at the factory.