Filter
Top Products
54
Change the PIN Code
Change the PIN code
CAUTION:
WHEN YOU HAVE CHANGED THE PIN CODE, WRITE DOWN
A NEW PIN CODE IN COLUMN OF THE PIN CODE NO. MEMO
ON PAGE 76, AND KEEP IT SECURELY. IF YOU FORGET YOUR
PIN CODE, THE PROJECTOR CAN NO LONGER BE STARTED.
The PIN code can be changed to your desired four-digit number.
Press the Point d buttons to select “PIN code change” and press
the OK button. The New PIN code input dialog box appears. Set a
new PIN code.
Lamp counter
This function is used to reset the lamp counter.
When the lamp life reaches a recommended lamp replacement
time, the time shown in the dialog box turns red and the Lamp
replacement icon appears on the screen, indicating that the end of
lamp life is approaching.
When replacing the projection lamp, reset the lamp counter. See
“Resetting the Lamp Counter” on page 60.
This icon appears on the screen when the end of lamp life is
approaching.
✔Note:
• This icon also appears at turning on and
selecting input source.
✔Note:
• The Lamp replacement icon will not appear when the Display
function is set to “Off” (p.48), during “Freeze” (p.28), or “Blank”
(p.29).
Change the PIN Code Lock setting
Change the PIN code lock setting
Use the Point 7 8
buttons to switch
between the options.
Enter a PIN code
Use the Point 7 8 button to select Off, On1, or On2 and then
move the pointer to “Quit” with the Point d button. Press the OK
button to close the dialog box.
After a correct Logo PIN code is
entered, the following dialog box
appears.
Enter a PIN code
Use the Point ed buttons on the side control or Number buttons
on the remote control unit to enter a number.
When using side control
Use the Point ed buttons on the side control to select a number.
Press the Point 8 button to fix the number and move the red
frame pointer to the next box. The number changes to “✳.”
Repeat this step to complete entering a four-digit number. After
entering the four-digit number, move the pointer to “Set.” Press
the OK button so that you can change the PIN code lock setting.
When using remote control unit
Press the Number buttons on the remote control unit to enter a
number (p.14). When you complete entering a four-digit number,
the pointer moves to “Set.” Press the OK button so that you can
change the PIN code lock setting.
If you fixed an incorrect number, use the Point 7 button to move
the pointer to the number you want to correct, and then enter the
correct number.
If you entered an incorrect PIN code, “PIN code” and the number
(✳✳✳✳) will turn red for a moment. Enter the correct PIN code all
over again.
Setting
NOTE:
If you forget your PIN code and unable to change
it, the PIN code can be reset to the factory default
setting (1234) according to the following procedures.
When you reset the PIN code, the Logo PIN code and
Key lock will be reset, as well.
1. Unplug the AC Power Cord from the AC outlet.
2. Hold down the OK button on the projector and
connect the AC Power Cord into the outlet again.
Keep holding down the OK button until the POWER
indicator lights. The PIN code returns to the factory
default setting while the PIN code lock state will
remain the same as the previous set state.