Canon LV-S2 Projector User Manual


 
12
CONNECTING THE PROJECTOR
VIDEO IN
RGB IN
RESET
COMPUTER
AUDIO IN
AV AUDIO IN
AUDIO OUT
SVIDEO IN
CONTROL
Y –– Pb / Cb –– Pr / Cr
ON
1
DIP
ON
OFF
23456
13" MODE (640 x 480)
16" MODE (832 x 624)
19" MODE (1024 x 768)
OFFON ON
ON ON
ON ON
OFF OFF OFF
OFFOFF OFF OFF
OFF OFF OFF OFF
123456
OFF OFFON ONON ON21" MODE (1152 x 870)
CONNECTING TO A COMPUTER
IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
VGA Cable
Monitor Output
Desktop type Laptop type
Audio Speaker
(stereo)
Audio Amplifier
Control Cable
for Serial Port
Audio Cable
(stereo)
Terminal
Serial port PS/2 port
Audio Output
Audio Input
CONTROL PORT
AUDIO OUT
COMPUTER AUDIO IN
RGB IN
ADB port
Cables used for connection ( = Cable or adapter is not supplied with this projector.)
Control Cable
for PS/2 Port
Control Cable
for ADB Port
Audio
Cable
(stereo)
NOTE :
When connecting the cable, the power
cords of both the projector and the external
equipment should be disconnected from
AC outlet. Turn the projector and
peripheral equipment on before the
computer is switched on.
USB port
MAC Adapter
Set slide switches
according to the
chart below.
VGA Cable (HDB 15 pin)
Control Cable for PS/2 Port
, Serial Port , or ADB Port
USB Cable
MAC Adapter (When connecting to Macintosh computer)
Audio Cable (Mini Plug (stereo) x 1)
External Audio Equipment
Terminals
of the Projector
Terminal
Terminal
USB
Set switches as shown in the table
below depending on RESOLUTION
MODE that you want to use before
you turn on projector and computer.
MAC ADAPTER (Not supplied)
USB
Cable
Use one of these Control Cables
or USB Cable corresponding
with the terminal of your
computer only when controlling
the computer with the optional
Wireless Remote Control Unit.
Downloaded from www.Manualslib.com manuals search engine