Filter
Top Products
Preparation for Protocol Settings
2-6
Specifying the Network Settings
2
Checking the Current Network Settings
You can check the network settings of the machine.
Settings specified from the
operation panel become effective after the machine is restarted, after the procedure.
1
Press [Menu].
2
Press [ (-)] or [ (+)] to select <NETWORK SETTINGS> ➞ press
[Set].
3
Press [ (-)] or [ (+)] to select <VIEW IP ADDRESS> ➞ press [Set].
4
Press [ (-)] or [ (+)] to select <IP ADDRESS>, <SUBNET MASK>,
or <DEFAULT GATEWAY> for displaying the setting you want to
check ➞ press [Set].
5
Press [Stop/Reset] to return to the standby display.
Settings Using ARP/PING Commands
1
Start up the MS-DOS prompt or the Command prompt on your
computer.
2
Execute the following command to add a static entry to the arp
table.
arp -s <IP Address> <MAC Address>
IP Address: Specify the IP address you want to allocate to the machine.
The IP address consists of 4 numbers ranging from 0 to 255,
using periods (.) as separators. (ie. 172.20.88.125)
MAC Address: Specify the MAC address of the machine. Every second digit
is separated by “-”. (ie. 00-00-85-05-70-31)
Input Example: arp -s 172.20.88.125 00-00-85-05-70-31