Filter
Top Products
5-76 Axxius 800 - Release 2.2
CLI Commands
set
set (ds0)
Use the set (ds0) command to setup one or all DS0s in a DS1. The command specifies DS0 or
range of DS0s, and the setting to apply.
set(ds0) signal
Use the set (ds0) signal command to setup one or all DS0s in a DS1 signal.
Syntax: set {ds0-addr} signal {emdw|emi|emicpd|emw|gs|ls}
Example: set a:1:1-4 signal emi
To set the signal type to E&M immediate start for channels 1-4, port 1, slot A
on a DS1 Controller.
{ds0-addr}
The Controller DS0 addresses are different on the DS3 and DS1 Controller, however the
DS0 address on the service cards does not change with Controller type (DS3 or DS1).
{emdw|emi|emicpd|emw|gs|ls}
DS0 Address on a DS3 Controller in the form {slot:port:channel:sub-channel}
slot A for the DS3 Controller card.
port Port number, range or all.
ds1 channel DS1 channel number, range or all.
ds0 channel DS0 channel number, range or all.
DS0 Address on a DS1 Controller or service cards (with DS1 or DS3 controller) in
the form {slot:port:channel}
slot A for the DS1 Controller card, or 1-8 for service cards.
port Port number, range or all.
channel Channel number, range or all.
emdw E&M delayed wink start. Used for ANI/DNS
emi E&M immediate start with ringback
(used for D3 PLAR and DPT)
emicpd E&M immediate start with calling party disconnect with ringback
emw E&M wink start
gs Ground start signaling
ls Loop start signaling