Filter
Top Products
Axxius 800 - Release 2.2 5-121
CLI Commands
set
set (router) port prompt
Use the set (router) port prompt command to set the authentication prompt on a TSR port.
Syntax: set {tsr_card-addr} port {port-number} prompt
{disable|enable}
Example: set 1 port 2 prompt enable
This command will enable the authentication prompt for port 2 on the TSR card
in slot 1.
{tsr_card-addr}
The slot number (1-8) that contains the TSR card.
{port-number}
The port number (1-4) of the TSR card.
{disable|enable}
set (router) port protocolport
Use the set (router) port protocolport command to set the protocol port on a TSR port.
Syntax: set {tsr_card-addr} port {port-number} protocolport
{protocol-port}
Example: set 1 port 2 protocolport 1024
This command will set the protocol port to 1024 for port 2 on the TSR card in
slot 1.
{tsr_card-addr}
The slot number (1-8) that contains the TSR card.
{port-number}
The port number (1-4) of the TSR card.
{protocol-port}
The protocol port range is 1 - 65525. 0 is the wildcard, any port designator.
disable Disable the Authentication Prompt on a TSR port
enable Set the Authentication Prompt on a TSR port