Filter
Top Products
Axxius 800 - Release 2.2 5-181
CLI Commands
show
show (ds0)
The show (ds0) command displays settings for DS0s.
Syntax: show {ds0-addr}
Example: show a:2:1-2
In the following example, the show (ds0) command has queried slot A
(Controller card), port 2, channels 1 through 2.
>show a:2:1-2
SLOT A:
Settings for DS1 1: channel 1:
Type: DATA
SLOT A:
Settings for DS1 1: channel 2:
Type: DATA
{ds0-addr}
The Controller DS0 addresses are different on the DS3 and DS1 Controller, however the
DS0 address on the service cards does not change with Controller type (DS3 or DS1).
DS0 Address on a DS3 Controller in the form {slot:port:channel:sub-channel}
slot A for the DS3 Controller card.
port Port number, range or all.
ds1 channel DS1 channel number, range or all.
ds0 channel DS0 channel number, range or all.
DS0 Address on a DS1 Controller or service cards (with DS1 or DS3 controller) in
the form {slot:port:channel}
slot A for the DS1 Controller card, or 1-8 for service cards.
port Port number, range or all.
channel Channel number, range or all.