Filter
Top Products
5-122 Axxius 800 - Release 2.2
CLI Commands
set
set (router) port stopbits
Use the set (router) port stopbits command to set the number of stop bits on a TSR port.
The stop bit is an interval at the end of each Asynchronous Character that allows the
receiving computer to pause before the start of the next character.
Syntax: set {tsr_card-addr} port {port-number} stopbits
{1|1.5|2}
Example: set 5 port 2 stopbits 1
The example will set the number of stop bits on the second port on the TSR card
in slot 5 to 1.
{tsr_card-addr} - The slot number (1-8) that contains the TSR card.
{port-number} - The port number (1-4) of the TSR card.
{1|1.5|2}
Stop bits values available. Note: If 1.5 Stop Bits is selected, the Data Bits setting MUST
be 5 Data Bits, if 2 Stop Bits is selected, 5 Data Bits MUST NOT be selected.
set (router) port tbos map description
Use the set (router) port tbos map description command to set a description attribute for
one of the eight available TBOS displays. This setting can be issued when the card is
physically strapped for Ethernet, but has no effect. This setting can be done for any
application type but is only used when type is set to TBOS.
Note: this command is only available on a TSR card that has TBOS feature enabled.
Syntax: set {tsr_card-addr} port {port-number} tbos map {map-
addr} description {"text-string"}
Example: set 5 port 2 tbos map 4 description "Site 7, St. Louis,
MO"
{tsr_card-addr} - The slot number (1-8) that contains the TSR card.
{port-number} - The port number (1-4) of the TSR card.
{map-addr}
One of the eight TBOS displays available for monitoring equipment. Range is 1 - 8.
{"text-string"}
The TBOS map description command assigns a text string (0 - 19 characters) to a
designated display number. Default is an empty string ("").