Filter
Top Products
Projection Operations
12
You can use the remote controller keys to adjust the volume level of the audio that is output
from the projector’s speaker.
To adjust the volume level
1. On the remote controller, press the [VOL +] or [VOL –] key.
z This causes the [Volume] screen to appear on the projected image.
2. Press the [VOL +] key or the [X] key to increase the volume, or the
[VOL –] or [W] key to lower the volume.
3. To close the setup screen, move the cursor to “Close”, and then press
the [ENTER] key.
z You can also close the setup screen by pressing the [ESC] key.
The mute function causes the projected image to go to black screen, and stop output of the
audio from the speaker.
To mute the image and audio
1. On the remote controller, press the [MUTE] key.
z This causes the projected image to go to a black screen, and stops output from the
speaker.
2. To restore the image and audio, press the [MUTE] key again or press
the [ESC] key.
Adjusting the Volume Level (VOL +/–)
Muting the Image and Audio (MUTE)