Filter
Top Products
35
Using the Setup Menu
z Turning on “Ceiling Mount” automatically turns off “Detailed Settings J Low-noise Mode”
(page 36). Note that the setting for “Low-noise Mode” remains “Off” even if you turn
“Ceiling Mount” back off again.
z The “Low-noise Mode” setting cannot be changed while “Ceiling Mount” is turned on.
z Unplug the AC power cord from the power outlet if you do not plan to use it for a long
time.
z If you do not unplug the AC power cord when “Ceiling Mount” is turned on, the cooling
fan will continue to operate after you turn off the projector. This is normal and does not
indicate malfunction.
■Screen Settings
J
Restore Menu Defaults
This sub-menu returns all of the sub-menu items on the Screen settings main menu to their
initial default settings.
z You can perform initialization even when there is no input signal. In this case, the
initialization is performed for the currently selected input source.
z Basically, initialization initializes the settings of the current input source. Note, however, that
the following settings are always initialized, regardless of the currently selected input
source.
Keystone Correction
Projection Mode
Ceiling Mount
z For details about the initialization procedure, see “To initialize the settings of a particular
main menu item” on page 25.
z Initializing these settings when “Detailed Settings J Advanced Settings 1 J Auto
Keystone Correction” is turned on causes automatic keystone correction to be performed
after initialization is complete, which causes “Keystone Correction” setting to show a
corrected value.
Detailed Settings
■Detailed Settings
J
Volume
This sub-menu can be used to adjust the volume level of the projector’s speaker. This setting
is also linked to volume settings made with the remote controller’s [VOL +] and [VOL –] keys.
z Changing this setting when there is no input signal changes the volume setting of the
currently selected signal source.
z A different setting is stored for each input source.