Filter
Top Products
Using the Setup Menu
16
Using the Setup Menu
Pressing the [MENU] key while an image is being projected displays the setup menu on the
projected image. The setup menu can be used to configure a variety of different projector
settings. The following table shows the menu items that are available in the Setup Menu.
Setup Menu Overview
Main menu Sub-menu Sub-menu Item Type
∗1
Input source
∗2
See page
RCSV –
Image
Adjustment
Brightness Value Setting 27
Contrast Value Setting 27
Sharpness Value Setting 27
Saturation Value Setting 27
Tint Value Setting ∗3 ∗327
Color Mode Setting Screen 28
Color Balance Setting Screen 28
Restore Menu Defaults Execution 29
Signal
Settings
Vertical Position Value Setting 30
Horizontal Position Value Setting 30
Frequency Value Setting 30
Phase Value Setting 30
Noise Filter Selection 31
Restore Menu Defaults Execution 31
Screen
Settings
Keystone Correction Value Setting 31
Aspect Ratio Selection ∗432
Resize Image To Fit Selection 33
Projection Mode Selection 34
Ceiling Mount
∗11 Selection 34
Restore Menu Defaults Execution 35
∗1 This is the sub-menu item type. Refer to the pages noted below for more information.
Value Setting: Specifies a numeric value () page 22).
Selection: Allows selection from multiple options () page 22).
Setting Screen: Numeric value specification or option selection on a separate setting
screen () page 23).
Execution: Initializes a setting () page 24).
Information: Displays information only () page 24).
∗2 These columns indicate whether each item appears ( ) or not ( ) for each input
source (R = RGB, C = Component, S = S-VIDEO, V = Video, – = No input signal).
∗3 This setting can be configured only for an NTSC or NTSC4.43 signal.
∗4 This setting can be selected only when the aspect ratio of the input signal is 4:3.