Filter
Top Products
53
Appendix
z Always make sure that the projector has cooled sufficiently before cleaning it. If the
projector is turned on, perform the following steps before cleaning it.
1. Turn off the projector.
2. Check to make sure that the POWER/STANDBY indicator has changed to amber.
3. Unplug the power cord from the power outlet, and allow the projector to cool down for
about 60 minutes.
Cleaning the Projector Exterior
Wipe the exterior of the projector with a soft cloth that has been moistened in a weak
solution of water and a mild neutral detergent. Be sure to wring all excess moisture from the
cloth before wiping.
Never use benzene, alcohol, thinner, or any other volatile agent for cleaning.
Cleaning the Lens
Carefully wipe the lens with a lens cloth or lens cleaning paper, which you should be able to
purchase from a nearby eye wear or camera shop. When cleaning the lens, be very careful
to avoid scratching it.
Cleaning Intake and Exhaust Vents
Dust and dirt tend to collect around the intake vents located on the bottom of the projector.
Because of this, you should use a vacuum cleaner to clean away accumulated dust and dirt
periodically as shown below. When cleaning vents, you should set the vacuum clear to its
lowest power setting.
Cleaning the Projector