Filter
Top Products
Quick Start
3. Press the Clear key.
4. Select
1: yes.
5. Press the
Clear key to return to the system menu.
6. Select
4: Transmit, 4: Utility and 4: Change memory size.
7. Enter
640 and then press the Enter key.
8. Select
yes to change the size.
9. Press the
Clear key to return to the system menu.
10. Select
1: Execute AP.
11. Select
Enter for “yes” to execute the AP.
The terminal is now configured to accept a download from Twin Client Manager.
Starting a Telnet Session
At the Twin Client main menu on the terminal, press any key to establish the connection.
Until the terminal has been authorized, the following screen is displayed.
RECOVERABLE ERROR
Terminal not
Authorized for
Twin Client
Keypress to Continue
It is not necessary to authorize the terminal at this time, so press any key to continue. The
terminal will establish a connection with the host system and start emulation. If the
terminal fails to connect to the host, refer to the following table for the possible causes
and the related corrective actions.
Failure Cause Corrective Action
Incorrect Host IP address Correct the Host List address on the terminal. Refer to
Terminal Setup Using Twin Client Menus under Standard
Setup for instructions.
Incorrect netmask value Access Radio Setup menu and correct the netmask value.
Refer to Terminal Setup Using Twin Client Menus for
instructions.
After a Telnet session has been successfully established, the terminal will remain in
session for a maximum of 30 minutes at a time until it has been authorized. Once
authorized, there is no software restriction on the session time. The instructions for
authorizing the terminal are presented in Authorizing PowerNet.
Supported Equipment Manual
•
March, 2006
2-11