Filter
Top Products
E-43
5. Drive the other screw into the wall at the location where the lower hole is located.
6. Drive the upper screw and lower screw into the wall the rest of the way.
To remove the Bridge Satellite Cradle from the wall
1. Loosen the upper screw and lower screw.
2. Raise the Bridge Satellite Cradle and remove it from the screws.
Important!
• While the Bridge Satellite Cradle is mounted on a wall, be sure to check the wall
screws periodically for looseness. Tighten them as required.
• Note use of the RS-232C cable is not supported by the wall-mounted
configuration. Connect using a USB cable or RS-422 cable.
DT-X11_E_P37_52.p65 06.2.6, 4:39 PM43