Filter
Top Products
E-55
Using PC Card (DT-X11M30E / M30U / M10E)
Your Handheld Terminal supports use of PC cards (PCMCIA card, compact flash card
with a CF card adaptor). Use the following procedure to load and remove PC cards.
Affixing a PC Card Remover
Once loaded, the PC card may be difficult to remove from the PC card slot.
Affixing a PC card remover (a piece of tape) to the PC card before you load it makes it
easier to pull the card out of the slot later.
Important!
When you use a compact flash card, always affix the PC card remover to the PC
card adaptor, not on the compact flash card itself whenever loading into the
Handheld Terminal. If you affix the tape to the compact flash card instead of the
adaptor, pulling the remover may end up pulling out the compact flash card only,
and make it impossible to remove the adaptor.
To load a PC card
1. Carefully lift up either end of the rubber PC card slot cover, and remove the four
screws that secure it in place.
Important!
Be gentle when lifting up the ends of the PC card slot cover rubber to expose the
screws. Pulling on the rubber or other rough handling can cause the rubber to
break.
• Installing a large-size PC card such as communication card may cause the PC card
slot cover rubber not to be put back. If you face to such the accident use either the
communication card cover (DT-892TCV) or the large-size communication card cover
(DT-893LTCV) both optional to protect the slot and the installed PC card itself.
PC Card Remover
Direction to insert
DT-X11_E_P53_59.p65 06.2.6, 4:40 PM55