Filter
Top Products
100
Other Settings (Set Up)
Procedure
MENU * Setup * Calibrate TP
Calibrate the touch panel whenever a touch operation does not produce the desired
results or if touch panel response is poor.
1. Touch “Start”.
2. Use the stylus to touch the centers of each
of the four cross marks (+) as they appear on
the screen. Take your time when performing
this operation and wait until the next cross
appears.
The message “Complete” indicates that touch
panel calibration is complete.
• Carefully touch the center of each cross mark (+).
• When calibrating the touch panel, position and hold the camera as you do
during normal shooting (page 15).
Procedure
MENU * Setup * HDMI
Use this setting to select the digital signal format when connecting to a TV with an
HDMI cable.
* 1080i corresponds to 1080 60i, but not 1080 50i. Because of this, the required
output method may be 576p when outputting to a digital TV in a PAL reception area
that does not support 1080i 60i. If you are in a PAL reception area and nothing is
displayed automatically, change the setting to 576p.
• If an image does not appear when “Auto” is selected as the output method, try
changing this setting to something else.
Calibrating the Touch Panel (Calibrate TP)
Selecting the HDMI Terminal Output Method (HDMI)
Auto
This setting will cause the format to change automatically in accordance
with the connected TV. Normally, you should use this mode.
1080i 1080i format output*
480p 480p format output
576p 576p format output