Filter
Top Products
TE-4000F/4500F User's Manual
115
E
Troubleshooting
Troubleshooting
Error
code
Message Meaning Action
E046
E047
E048
E049
E050
E051
E053
E054
E055
E059
E060
E061
E062
E063
E064
E066
E075
E085
E099
E100
E101
E105
E106
E121
E139
E140
E146
E200
E203
E205
REG buffer full
Print bill
Insert slip
paper and retry
CHECK memory
full
DETAIL memory
full
CHK/TBL No. is
occupied
CHK/TBL No. is
not opened
Out of CHK/TBL
No. range
In the SEP CHK
operation
Press EAT-IN or
TAKE-OUT key
Printer offline
Printer error
Printer paper
end
Printer busy
Print buffer
full
Print from the
beginning of the
transaction
Negative balance
cannot be
finalized
Data exist in
consolidation
file
Check NFP items
Operate at the
master terminal
PLU maintenance
file full. Press
<#2> to exit
PLU file full
Item exists in
the PLU FILE
Inline startup
error
Negative balance
is not allowed
Wrong menu
Arrangement file
full
Insert CF card
Insufficient
memory
File already
exist.
Registration buffer full.
Separate check buffer full.
Attempt to register a new transaction without printing slip.
No paper is inserted or paper is out in the slip printer.
Check tracking index memory full.
Check tracking detail memory full.
Attempt to made use <New Check> to open a new check
using a number that is already used for an existing check in
check tracking memory.
Attempt made to use <Old Check> reopen a new check using
a number that is not used for an existing check in check
tracking memory.
Check number range over.
Normal registration is prohibited during separate check
operation.
Attempt to finalize a transaction without specifying <EAT-
IN> or <TAKE-OUT>.
External printer offline
External printer went down.
External printer paper end
External printer is now printing.
Printing buffer full
Attempt to print the last separated transaction on slip.
Attempt to finalize a transaction when balance is less than or
equal to zero.
Data exists in the consolidation file.
Disable to read/reset or consolidate the not found PLU item.
Prohibit master operation.
Scanning PLU direct maintenance/batch maintenance file
becomes full.
Scanning PLU/not found PLU file full
The designated item has already existed in the scanning PLU
file.
Network startup error.
Attempt to register <–> or <CPN> when the balance becomes
negative.
This sheet holder is prohibited by PGM.
Arrangement file is full.
No CF card is set.
Insufficient memory in the CF card.
Can not write, because designated file has already been in the
CF card.
Finalize the transaction.
Allocate sufficient separate check buffer.
Perform slip printing operation.
Insert new slip paper.
Finalize and close the check number currently used.
Finalize and close the check number currently used.
Finalize and close the check that is currently under the
number that you want to use or use a different check number.
Use the correct check number (if you want to reopen a check
that already exists in check tracking memory) or use <New
Check> to open a new check.
Enter correct number.
Terminate separate check operation.
Press <EAT-IN> or <TAKE-OUT>.
Replace new paper.
Print from the beginning of the transaction
Register item(s) until the balance becomes positive amount.
Clear the data.
Perform it at master terminal.
Terminate the maintenance.
Modify the designated item.
Enter proper minus/coupon amount.
Set correct sheet holder.
Set the arrangement properly.
Set CF card.
Use a vacant (formatted) CF card.
Check the operation and retry.