Filter
Top Products
10
Important!
Be sure to use alkaline batteries only.
Replacing Remote Controller Batteries
Open the battery cover on the back of the remote controller, replace the old batteries with new ones,
and then close the battery cover.
Place the projector onto a table, desk, or stand that is level and firm, making sure you allow enough
room around it. Best results can be obtained when the projector is pointed directly at the screen, and
not at an angle.
z The projector can be configured for projection from the back of a screen. For details, see
“Projection Mode” (page 42) under “Screen Settings Main Menu”.
Loading Remote Controller Batteries
*
Caution
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
1.
Open the battery cover on the back
of the remote controller.
2.
Load two new batteries into the
case, making sure that their positive
(+) and negative (–) ends are facing
correctly.
3.
Close the battery cover on the back of the remote controller.
Setting Up the Projector
XJ-H1600/XJ-H1650/XJ-H1700/XJ-H1750 XJ-H2600/XJ-H2650/XJ-ST145/XJ-ST155
Screen
Screen