Filter
Top Products
Configuration Section 3
WR850 3-35
To add a Packet Filter entry:
1 Enter a descriptive name in the Packet Filter Name field.
2 From the Filter Action drop-down list, select Allow or Deny. Allow permits data that
meets the criteria selected. Deny blocks the data that meets the selected criteria.
3 From the Packet Direction drop-down list, select Inbound or Outbound, based on
whether you want to monitor incoming or outgoing packets.
4 From the Packet Protocol drop-down list, select the type of protocol to monitor: TCP,
UPD, ICMP, or ALL.
5 Enter the IP range in the Source IP Range field.
6 Enter the port range in the Source Port Begins and Ends fields.
7 Enter the Destination IP range in the Destination IP Range field.
8 Enter the Destination Port range in the Destination Port Begins and Ends fields.
9 Click Add to add the entry.
10 Click Apply to save the entry. To cancel your changes, click Cancel.
To update or remove an entry, select it and then click Edit or Remove to perform the
action.
The position of the Packet Filter entry determines the order in which the policy will be
applied.