Filter
Top Products
E Series User Manual
020-000515-01 Rev. 2 (03-2013)
Section 3: Installation
3-3
3.3 Turn the Projector On
Ensure that the power cord and signal cable are securely connected. The 1.
Power button on the built in keypad is illuminated.
1 2 3 4 5 6 7 8 9
10
11 12 13 14 15 16 17 18 19 20
Turn on the lamp by pressing 2.
“ ”
on the remote control or press
“ ”
on
the built-in keypad.
1 2 3 4 5 6 7 8 9
10
11 12 13 14 15 16 17 18 19 20
The STATUS LED is yellow and LAMP LED is green
with a long blink.
The startup screen displays in approximately 10 seconds.
Turn on the source. Select Input Key on the remote control to select 3.
an input source (VGA, BNC, HDMI1, HDMI2, Component, S-Video or
Composite Video).
1 2 3 4 5 6 7 8 9
10
11 12 13 14 15 16 17 18 19 20
The projector detects the source you selected and displays the image.4.
NOTE:
The rst time the projector is used, the preferred language may be selected from the main menu after the startup screen is
displayed.
3.4 Turn the Projector Off
Press 1.
“ ”
on the built-in keypad or on the remote control to turn off the
projector. A warning message will appear on the displayed image.
Press 2.
“ ”
again to conrm your selection. If you do not press
“ ”
again,
the warning message will disappear after 10 seconds.
Input Key
1 2 3 4 5 6 7 8 9
10
11 12 13 14 15 16 17 18 19 20
Power on
1 2 3 4 5 6 7 8 9
10
11 12 13 14 15 16 17 18 19 20
Status LED
1 2 3 4 5 6 7 8 9
10
11 12 13 14 15 16 17 18 19 20
Power on
1 2 3 4 5 6 7 8 9
10
11 12 13 14 15 16 17 18 19 20