Filter
Top Products
E Series User Manual
020-000515-01 Rev. 2 (03-2013)
Section 4: Operation
4-16
4.4 Lamp Menu
Lamp Mode
Select Constant Power or Constant Intensity mode.
Constant Power
Set the value of the lamp power (in Watts).
Constant Intensity
Set the value for the Constant Intensity to maintain constant brightness. A light
sensor is used to monitor the light level and will apply more power as the lamp
brightness decays naturally over time until it reaches maximum power. The
light sensor needs to be calibrated when you replace a lamp or "Reset Lamp
Hours".
Current Lamp
Select which lamp(s) is in use.
NOTE:
A 120 second timed lockout is applied after changing modes before you can change it again.
Eco Mode
Set Eco mode ON, OFF, Auto or assign a lamp to Eco mode. When Eco Mode
is enabled, the projector will switch to single lamp mode, adjust to the lowest
fan speed and switch the lamp power to the minimum setting.
Lamp Auto Switch
Control when the projector switches lamps. Options include: on failure only, at