Filter
Top Products
E Series User Manual
020-000515-01 Rev. 2 (03-2013)
Section 4: Operation
4-25
Start IP = 192.168.1.100 -
End IP = 192.168.1.120 -
Subnet Mask = 255.255.255.0 -
Default Gateway = 192.168.1.100 -
SNMP Settings: -
SNMP Read Communication = private -
Trap IP Address = 0.0.0.0 -
SMTP IP Address = 0.0.0.0 -
All other settings are cleared/blanked -
Trap Conguration: -
All items = SNMP Trap + Email -
LAN Panel
y
Enter the IP address, subnet mask, default gateway for the LAN setting
Select if the projector must obtain an automatically assigned IP address -
through DHCP or if the user will set the address manually.
Enter the IP address, netmask, default gateway and DNS server -
address for the TCP/IP setting
WLAN Panel
y
Select if Enable or Disable the WLAN function. -
Enter Start IP, End IP, Subnet Mask, Default Gateway for the WLAN -
setting.
SNMP Panel
y
The E Series SNMP (Simple Network Management Protocol) interface -
provides network administrators with a common way to manage their
network devices from a single remote location. SNMP allows an
administrator to query a number of devices to see their current status/
conguration. It also allows operators to change conguration values
and congure trap or Email notications to be sent when certain events
occur.(eg. Loss of signal, power state change, etc)
Emails are sent to the mail server congured in the projector
`
settings. Up to 2 user email accounts can be selected. Any
important information regarding the event will be located in the body
content of the email.
SNMP Traps are notications that are sent from the projector. They
`
are only received by a trap receiver (MIB Browser) in the computer.
SNMP Read Community (default setting: private) – this is a plain- -
text password. This must also be entered in the MIB browser. This
password allows the various settings in the projector to be queried.