Filter
Top Products
Send document comments to nexus5kdocs@cisco.com
3-22
Cisco Nexus 2000 Series Hardware Installation Guide
OL-19013-05
Chapter 3 Installing a Cisco Nexus 2000 Series Fabric Extender
Repacking the Cisco Nexus 2000 Series Fabric Extender for Return Shipment
Step 4 Listen for the fans if the device is powered on. You should immediately hear them operating. If you do
not hear them, ensure that the fan tray is inserted completely in the chassis and the faceplate is flush with
the outside surface of the chassis.
Step 5 Verify that the LED is green. If the LED is not green, one or more fans are faulty. If this problem occurs,
contact your customer service representative for a replacement part.
Note If you purchased this product through a Cisco reseller, contact the reseller directly for technical support.
If you purchased this product directly from Cisco, contact Cisco Technical Support at this URL:
http://www.cisco.com/en/US/support/tsd_cisco_worldwide_contacts.html.
Removing the Cisco Nexus 2000 Series Fabric Extender
Caution The slider rail and front rack-mount brackets do not have a stop mechanism when sliding in and out. If
the front of the chassis is unfastened from the rack and the chassis slides forward on the slider rails, it
may slip off the end of the rails and fall out of the rack.
To remove the Cisco Nexus 2000 Series FEX from a rack, follow these steps:
Step 1 Ensure that the weight of the FEX is fully supported and that the device is being held by another person.
Step 2 Turn off the power at the circuit breaker.
Step 3 Disconnect the power cord as follows:
• For AC power supplies, disconnect the power cord and the console cables.
• For DC power supplies, disconnect the positive cable from the negative (-) terminal, and disconnect
the negative cable from the positive (+) terminal.
Step 4 Disconnect all ports.
Step 5 Remove the screws that fasten the front rack-mount brackets to the mounting rails.
Step 6 Gently slide the chassis toward you, off of the slider rails and out of the rack.
Repacking the Cisco Nexus 2000 Series Fabric Extender for
Return Shipment
If you need to return the Cisco Nexus 2000 Series FEX, remove the device from the rack by following
the steps in the “Removing the Cisco Nexus 2000 Series Fabric Extender” section on page 3-22, and
repack it for shipment. If possible, use the original packing materials and container to repack the device.
Contact your Cisco customer service representative to arrange for return shipment to Cisco.